Verilink WANsuite 5370 (34-00310.D) Product Manual Manual do Utilizador descarregar pdf (Página 147)

VT100 Interface 4-31

Message Size

Maximum number of octets to buffer before sending a frame.

Values: No, Yes

Default: No

Idle Character Delay

Maximum number of idle character time required before sending a frame.

Input Terminator

Decimal value of the character that terminates a message before sending a

frame.

Values: 0−255

Default: 0

Data Direction

Data direction that the port will support. If set to “Input,” the port will only

accept incoming data and will not transmit data. If set to “Output,” the port

will ignore any incoming data. If set to “Both,” the port will process all data.

Values: Input, Output, Both

Default: Both

SCADA Loopback

Determines if and where SCADA will loopback received data.

Values: None, Loopback to Network, Loopback to Port

Default: None

The table below these parameters displays the SCADA statistics. You can

clear all SCADA statistics by selecting the “SCADA Clear Statistics” prompt

at the bottom of the screen.

Select the “SCADA Device List” prompt to bring up a screen that shows the

mapping between SCADA devices and endpoints (Figure 4.27).

Figure 4.27

SCADA Device List

To bring up the “SCADA Device Details” (Figure 4.28) menu, select a

number from the “Device” column. This menu lets you map SCADA devices

to endpoints.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 234 235

Sem comentários

Verilink WANsuite 5370 (34-00310.D) Product Manual Manual do Utilizador Página 147