Verilink QUAD DATA (880-503319-001) Product Manual Manual do Utilizador Página 12

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 47
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 11
Overview
1-4 Verilink QUAD DATA User Manual
Normal Operation
The meaning of the various states is listed in Table 1-1.
Table 1-1 LED States
Local Port
The
LOCAL
port on the front of the QUAD DATA module is normally
not used. Configuration and maintenance of the QUAD DATA
module should be done by connecting to the
LOCAL
port of the
associated SCM 3000 controller module.
Rear Module
The rear connector module used with the QUAD DATA front module
is a DIM 3030 (DIM stands for Data Interface Module). See Figure
1-2.
Figure 1-2 DIM 3030 Rear Connector Module
Adapter Cables
The DIM 3030 rear connector module presents 4 mini D-Sub 26-pin
connectors for the data ports. Depending on which electrical
interface type and data port mode is selected in the
QUAD DATA
Configuration Menu
, an appropriate adapter cable must be used.
The adapter cables all have a mini D-Sub 26-pin connector at one
end and the typical connector for the selected electrical interface at
the other end.
If the data port mode is DCE, use one of the adapter cables in Table
1-2.
State Meaning
Not Lit The port is not in service. Use the
QUAD DATA
Configuration Menu
(
Figure 3-2
) to place the port in
service. If no LEDs are lit, the module has no power.
Solid Green Normal operation. There are no alarms, no loopbacks, and
the port is in service.
Solid Red Loss of Signal detection is enabled and the port detects that
DTR is not asserted.
Solid Amber A Data Port Loopback is active on the port.
Blinking
Amber to Red
The QUAD DATA module is sending a test pattern and
receiving errors.
DATA PORT 1
DATA PORT 2DATA PORT 3
DATA PORT 4
DIM
3030
Vista de página 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 46 47

Comentários a estes Manuais

Sem comentários