Verilink WANsuite 6450 (34-00326) Product Manual Manual do Utilizador descarregar pdf (Página 179)

VT100 Interface 4-71

Forward

Transmissions

Number of times this port has changed from any other state to a “Forwarding”

state.

Input Frame

Number of frames received.

Output Frame

Number of frames transmitted.

Input Discards

Number of frames discarded.

TFTP Configuration

A Trivial File Transfer Protocol (TFTP) service on a server can provide

remote file access to the WANsuite 6450 to

• Update the firmware on a WANsuite unit

• Save the configuration setup of a WANsuite unit

• Restore a saved configuration setup to a WANsuite unit

To transfer a file to or from a TFTP server from a WANsuite unit, you must

indicate the TFTP server’s IP address and file name, and then perform a Get

operation to receive a file from the server, or a Put operation to send a file to

the server. The file name and its extension determine the type of file

transferred.

The table below shows the possible file operations.

Note that when updating the application software using a .HEX file, the file

name should have the form xxAPxxxx.HEX; the AP indicates the file is an

application load. When updating the boot software, the file name should have

the form xxWBxxxx.HEX; the WB indicates the file is a boot load.

Operation File Name Extension Action

Update Application Firmware .CHX or .HEX(1) Get

Update Boot Firmware .HEX(2) Get

Save Configuration Setup .CFG Put

Restore Configuration Setup .CFG Get

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 204 205

Sem comentários

Verilink WANsuite 6450 (34-00326) Product Manual Manual do Utilizador Página 179