Verilink AS420 (34-00294) Product Manual Manual do Utilizador Página 19

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 28
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 18
Installation and Configuration 11
Firmware Download Procedure
This port is accessed through a direct connection. Configure the terminal for
VT100 emulation, 115200 bps, 8 bits, no parity, 1 stop bit.
NOTICE:
Commands to the unit are not case sensitive. When the word “enter”
is used in this manual, it means to press the Return or Enter key.
1
Begin the procedure by entering
AT
. The unit returns
OK
.”.
NOTICE:
The unit does not echo the typed characters.
2
Put the unit into download mode by entering
AT$Y
. The display will return
Ready for Flash download.
3
Initiate the download or file transfer utility in your communication’s
package.
4
Enter the desired binary file name (.BIN extension) to download. The
transfer can take one or two minutes. After the unit successfully receives the
file, the display will read,
Flash download was successful.
5
After successfully downloading the binary file, reset the unit by
disconnecting and reconnecting the power.
6
After the unit has reset, enter
ATI
to verify the new software version.
Reloading Previous Firmware
1
To reload the previous version of the firmware, enter
AT$P
. The display
will read,
Processing Previous Firmware.
2
After the firmware successfully loads, the unit returns “
OK
”.
3
After successfully downloading the binary file, reset the unit by
disconnecting and reconnecting the power.
4
To verify software, type
ATI
.
Power Bypass
The AS420 can operate in a power bypass mode where the AS420 passes the
signal from the network to the equipment and vice versa whether in a
powered state or not.
5RXD
6 Ground
7CTS*
8 Not Connected
Table 2.3
Supervisory Port Pinouts
Pin Description
Vista de página 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comentários a estes Manuais

Sem comentários