Verilink T1 Access Router (34-00327) Product Manual Manual do Utilizador descarregar pdf (Página 107)

Web Server Interface 3-79

• Save the configuration setup of a T1 Access Router unit

• Restore a saved configuration setup to a T1 Access Router unit

To transfer a file to or from a TFTP server from a T1 Access Router unit, you

must indicate the TFTP server’s IP address, the file name, and then perform a

Get operation to receive a file from the server, or a Put operation to send a

file to the server. The file name and its extension determine the type of file

transferred.

The table below shows the possible file operations.

Note that when updating the application software using a .HEX file, the

filename should have the form xxAPxxxx.HEX; the AP indicates the file is

an application load. When updating the boot software, the filename should

have the form xxWBxxxx.HEX; the WB indicates the file is a boot load.

Password

The Password Details screen (Figure 3.79) is used to modify the password

that restricts access to the Web Server interface.

Acceptable characters for use in a password are digits 0–9 and letters A–Z

and a–z, for a total of 62 distinct characters.

Figure 3.79

Password Details Screen

To change either the Admin or Read-Only password, you must enter it once

in the New Password field and then re-enter the same password in the

Confirm Password field. After entering the new password in both these fields,

click the “Change Admin Password” or the “Change Read Only Password”

button to update and establish the new password.

Operation Filename Extension Action

Update Application Firmware .CHX or .HEX(1) Get

Update Boot Firmware .HEX(2) Get

Save Configuration Setup .CFG Put

Restore Configuration Setup .CFG Get

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 196 197

Sem comentários

Verilink T1 Access Router (34-00327) Product Manual Manual do Utilizador Página 107