Verilink T1 Access Router (34-00327) Product Manual Manual do Utilizador descarregar pdf (Página 71)

Web Server Interface 3-43

Diagnostics

The Diagnostics screen (Figure 3.34) provides a table for viewing the current

settings for the test and maintenance functions performed on the available

interfaces. This screen shows an upper-level view of all the interfaces so you

can see if any port is under test, and, if so, view the results. You may change

Diagnostic parameters on the Test Details screen, which is accessed from a

button on the Diagnostics screen. The properties of the Diagnostics table are

described in the paragraphs below.

Figure 3.34

Diagnostics Screen

Description

Describes the type of interface selected for testing.

Loop Type

Describes the type of loop test (if any) performed on the selected interface.

Setting

Displays the bandwidth on which you wish to perform the BERT.

Pattern

Specifies the pattern to be transmitted during a BERT for the selected port.

Length

Displays the length of time for which the BERT should run for the selected

interface.

State

Displays the current BERT state for the selected interface.

Elapsed Time

Displays the time elapsed since a BERT began or, if completed, the total test

time.

Displays the total number of bit errors detected since the BERT began or

since error statistics were last cleared.

Displays the number of asynchronous errored seconds detected since the

BERT began or since error statistics were last cleared. This parameter

includes bit error seconds and sync loss seconds.

% EFS

Displays what percent of the total BERT time ran error free. This ratio is

derived from the number of error-free seconds divided by the number of

seconds accumulated in Elapsed Time.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 196 197

Sem comentários

Verilink T1 Access Router (34-00327) Product Manual Manual do Utilizador Página 71