Verilink T1 Access Router (34-00327) Product Manual Manual do Utilizador descarregar pdf (Página 158)

4-50 T1 Access Router

OSPF LSU Delay

The estimated number of seconds it takes to transmit a Link State Update

(LSU) packet over this circuit interface.

Values: 1−3600

Default: 1

OSPF Router Priority

This 8-bit unsigned integer ranges from 1 to 255 and assigns priority to one of

two routers attached to the same network; without an assigned priority, both

routers attempt to become the designated router.

Values: 1−255

Default: 1

OSPF Hello Interval

The time in seconds between the Hello packets that a router sends on a

circuit. This value is also advertised in the router’s Hello packets and must be

identical for all routers on the same network. The smaller the Hello Interval,

the sooner topological changes are detected (but then more traffic is created).

Values: 1−65535

Default: 1

OSPF Dead Interval

The number of seconds that a router’s “Hellos” have not been received before

its neighbors declare the router down. The value must be the same as the

value on the network.

Values: 1−65535

Default: 40

OSPF Auth Key

When configured, this parameter allows an authentication procedure to be

executed on the OSPF header. If the 64-bit (8 character) password does not

correspond, the packet is thrown away.

Values: 64 bits (8 characters)

Default: 8 spaces (no authentication)

Static Route Table Screen

Under some circumstances, it may not be necessary for a router to learn a

route using ordinary means such as RIP or OSPF. It is possible under these

circumstances for you to add a route to the route table of a router. The Static

Route menus are always associated with a circuit.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 196 197

Sem comentários

Verilink T1 Access Router (34-00327) Product Manual Manual do Utilizador Página 158