Verilink 8100A (34-00237) Product Manual Manual do Utilizador descarregar pdf (Página 221)

Command Line Interface 6-1

C HAPTER

HAPTER

OMMAND

INE

NTERFACE

Introduction

The command line interface (CLI) is often more convenient to use than the

menu interface. Many of the tasks you normally perform using the menu

interface are also available in the command line interface.

To enter CLI mode, type “C” on the Main menu (Figure 2.2). The IAD enters

command mode and allows you to enter IAD commands (described below)

until you type the exit command to return to the menu interface.

Any time you use the menu or CLI to make setting changes, or change any of

the physical characteristics of the IAD (such as changing the MAC address of

the Ethernet port), you must reset (or restart) the IAD for the new settings to

take effect. An alternative to issuing the reset command is to simply turn off

(or unplug) the IAD, and power it back on, forcing it to reboot.

CLI Help

Type help at the prompt to display a list of all CLI commands. To display

the parameters for a specific command, type the command followed by a

question mark (?) and press Enter. For example, set wan ip address?.

To obtain all commands that begin with the same phrase, type one or more

words of the command followed by a question mark (?) and press Enter. For

example, to see a list of commands that all begin with the phrase “set dhcp

relay,” type set dhcp relay? and press Enter. The following will

display:

set dhcp relay enable (off|on)

set dhcp relay server <ip-address>

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 310 311

Sem comentários

Verilink 8100A (34-00237) Product Manual Manual do Utilizador Página 221