Verilink 8100A (34-00237) Product Manual Manual do Utilizador descarregar pdf (Página 63)

Administration 3-13

5 The IAD prompts you to enter the IP address of the TFTP Server.

6 Type the IP address of the TFTP Server and press Enter.

As file transfer progresses, the IAD reports the status of each file being

copied. Two files − acos.bin and boot.bin − will only be copied if they match

the platform to guard against loading incorrect system files onto an IAD.

NOTICE: If the IAD cannot locate the first file to download (typically

release.dat), the update will fail. Make sure you have assigned a valid

IP address and subnet mask, and you’re on the same subnet as the

TFTP Server. Use the Ping command to ping the IAD and try again.

Upon completion, the IAD reports the success or failure of each file transfer,

and then reports the completion of file transfer and resets.

Verifying the Upgrade

To verify that the files downloaded successfully after being transferred,

observe the boot sequence. The IAD displays the software version in the

Verilink banner.

You may also display the current configuration (page 8-2) to validate the

firmware version.

Utilities Menu

The Utilities menu contains utility commands, including several menus to

upgrade IAD software and support ACOS application development.

To display the Utilities menu, type “9” on the Main menu.

Figure 3.6

Utilities Menu

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 310 311

Sem comentários

Verilink 8100A (34-00237) Product Manual Manual do Utilizador Página 63