Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador descarregar pdf (Página 112)

4-14 WANsuite 6x30

Figure 4.11

Configuration Profile Details Screen

This screen lets you configure or change the following information about the

selected configuration profile:

Profile Name

A 32-character string that identifies a Profile Name in the Span Profile table.

Each entry represents the complete span in an ATM line.

Wire Mode

Displays the type of wire interface used by the span (two-wire).

Data Rate (Min)

Sets the minimum attainable line rate in the span.

Data Rate (Max)

Sets the maximum attainable line rate in the span.

Remote

Enables/disables support for remote management of the units in an SHDSL

line from the STU-R via the EOC.

Values:

Enabled, Disabled

Default:

Enabled

Transmission Mode

Sets the regional setting of the span represented as a bit-map of possible

settings.

Values:

Annex-A

(ITU-T G.991.2)

, Annex-B

(ITU-T G.991.2)

Default:

Annex-B

To change any configuration profile parameter, enter the desired value/

information in a field or select the desired parameter from one of the pull-

down lists, and then press the “Esc” key.

Alarm Profiles Screen

Selecting the “Alarm Profiles” prompt on the WANsuite 6430’s Network

Config screen will display the screen shown in Figure 4.12.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 180 181

Sem comentários

Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador Página 112