Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador Página 21

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 181
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 20
About the WANsuite 6x30
1-5
The front panel
’s five
LED status indicators are de
scribed
below:
The user-activated input control buttons are de
scribed
below:
*The
CONFIG
button must be held until the
MODE
LED lights amber and remains illuminated for the
default configuration to take effect.
R
ear Panel Connections
The rear panel
s
of the WANsuite
6x30
product family differ from unit to unit.
Each is described below.
The WANsuite 6130
has five connectors. From left to right these are as
follows:
POWER
,
SUPERVISORY PORT
,
10/100 ETHERNET
,
SERIAL
INTERFACE
,
and
NET
as shown in Figure 1.2 below.
Figure 1.2
WANsuite 6130 Rear Panel
Indicator
Description
MODE
Normally, this indicator lights
green
.
The indicator lights
amber
while configuration is being set by the front panel
buttons or when the configuration is changed by SNMP or through the Web
interface. The indicator will remain amber until the changed configuration is
saved; it will revert to green when the new configuration has been saved.
NET
This indicator is off (not illuminated) when the Network port has not been
configured.
The indicator lights
green
when the Network port link is up and the ATM
protocol is established.
The indicator lights
red
when the Network port link is down and the ATM
protocol is not established.
The indicator lights
amber
when the Network port link is up but the ATM
protocol is not established.
SERIAL
This indicator is off (not illuminated) when the port has not been configured.
The indicator lights
green
when the serial port is active.
The indicator lights
amber
when the serial port is not active.
ALARM
This indicator lights
red
if an alarm condition exists.
The indicator lights
amber
if a “yellow” alarm condition exists.
POWER
This indicator lights
green
when power is applied to the unit.
The indicator lights
amber
in test modes (Port looped or BERT active).
Button
Description
RESET
Provides a hardware reset to the unit.
CONFIG
Sets the unit back to its factory default Ethernet or HDLC configuration; this is
the same as a maintenance reset.
To initiate this function, you must press and hold the
CONFIG
button during a
power-up sequence.*
Vista de página 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 180 181

Comentários a estes Manuais

Sem comentários