Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador descarregar pdf (Página 99)

VT100 Interface 4-1

HAPTER

VT100 I

Introduction

This chapter describes the menus and options associated with the WANsuite

6x30’s VT100 interface. In cases where all 6x30 VT100 configuration screens

are the same, only the 6130 screens showing various configurations are

displayed. However, where the configuration screens of the units differ, as in

the Network Interface screens and their submenus, each unit’s configuration

screens are displayed. Even when all screens resemble each other, parameter

values and/or defaults may vary from unit to unit; these differences are noted.

You can access the VT100 interface locally via the Supervisory port or

remotely through a TELNET session. To access the VT 100 screens locally,

verify the Supervisory type is “tty” and the Supervisory port speed matches

the terminal emulation program that’s being used. (Port speeds supported

include the following: 1200, 2400, 4800, 9600, 19200, 38400, 57600, and

115200 bps.) You can access the VT100 interface remotely by opening a

TELNET session, entering the unit’s IP address, and connecting to the unit.

All screens in this chapter were captured during a TELNET session.

Screen Components

The VT100 terminal screens have components common to all screens (see

Figure 4.1 below). These components include the device type (in the example

below, Verilink WANsuite 6130), which is centered on the screen, the

software and hardware revision numbers (upper left), the date and time (upper

right), the menu title (“Main” in the figure below), and the serial number

under which the unit is operating.

Figure 4.1

VT100 Terminal Screen Components

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 180 181

Sem comentários

Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador Página 99