Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador descarregar pdf (Página 122)

4-24 WANsuite 6x30

DTR Alarm Control

Lets you set DTR Alarm Control parameters. Selecting “Enable” allows the

unit to go into alarm on loss of DTR, which occurs when the Serial port

detects that the DTR signal is low.

Values:

Enable, Disable

Default:

Disable

DTR Alarm Status

Lets you view the current DTR Alarm status.

Format

Selects the port’s operating mode.

Values:

Sync, Async

Default:

Sync

Current Pin Status

Shows the status of the DTE Serial port pins.

Ethernet (IP Details) Screen

If you select “Ethernet” from the Interfaces screen, you will bring up an IP

Details screen (Figure 4.19) that lets you view and/or modify the IP

parameters listed below.

Figure 4.19

IP Details Screen

IP Address

A unique Network address assigned to this unit.

Subnet Mask

Defines the Network portion of the unit’s IP address.

Gateway Address

IP address of the default gateway (router) on the LAN side of the unit.

DHCP Client

If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and

Gateway addresses from a DHCP server located on the LAN side of the unit,

and the unit will use these addresses. If the DHCP request is unsuccessful, the

unit will use the configured addresses shown on this screen.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 180 181

Sem comentários

Verilink WANsuite 6x30 (34-00315.B) Product Manual Manual do Utilizador Página 122